RAW MATERIAL COMPOSITION AND GENERAL PHYSICAL CHARACTERISTICS

1.GENERAL RAW MATERIAL COMPOSITION
Wood Powder 55% High Density Polyethylene(HDPE) 30%
Filling 9.5% PE Additives 4%
Antimicrobial Agents 0.2% Antioxidant 0.5%
Master Batch 0.8%

2. GENERAL PHYSICAL CHARACTERISTICS
Density g / cu.cm 1.400 Tensile strength 29 Mpa
Modules of elasticity – Mpa 3500 Mpa Modules of rupture – Mpa 40 Mpa
Flexural strength – Mpa 45 Mpa Coefficient of friction 0.29
Coefficient of friction 0.4 thermal expansion 6×10-5 1/k
Water absorption 0.21% Termite resistance Anti-termite
Fungal resistance 0 Grade Is the product green certified? applied for

3. SIZE TOLERANCE AS PER EN 13489
Thickness ±0.5MM Length of the surface + 2-3MM
Width of the surface ±0.5MM Deviation from squareness ±0.5MM

CARE & FIXES GUIDE

Versa requires very little care. However, as an outdoor material, certain cleaning is required to keep your application looking good over time.

Please read this guide to help maintain your's well.

PROBLEM CARE & FIXES
Dust and Dirt Dust and dirt especially on decks needs to be cleaned by hosting with fresh water periodically. Stubborn debris can be pressure hosed and nylon brushed along the length of the profile. Mild soap solution with warm water can be used for persistent dirt.
Plant and Leaf Stains Brush away and hose off all loose plant matter, First use warm water with a mild detergent with brushing to remove stains.
If persistent use a stronger detergent with low concentration oxalic acid with brushing.
Garden Manure and
Red Soil
Brush away and hose off all loose matter. First use warm water with a mild detergent with brushing to remove stains. If persistent use a stronger detergent with low concentration oxalic acid with brushing
Salt Deposits Brush away and hose off all loose salt particles. Use warm water with a mild detergent with brushing to remove stains. If
persistent allow surface to dry and sand mildly to remove all traces of salt deposits.
Rust and Pigment Stains Brush away and hose the surface. First use warm water with a mild detergent with brushing to remove stains. If persistent use a stronger detergent with low concentration oxalic / phosphoric acid with brushing.
Cement and
Construction Debris
Brush away and high pressure hose off all cement particles. Use warm water with a mild detergent with hard bristle brushing to remove debris. If persistent allow surface to dry and sand mildly to remove all traces of cement deposits.
Food, Beverages and
Oil Stains
Hose surface with water first. Use any solution with content of acetone xylene or methanol and wipe the stains in the plank or section direction. If persistent sand mildly to remove stain and use solution again if necessary.
Paint Stains Hose surface with water first. Use any solution with content of acetone xylene or methanol and wipe the stains in the plank or section direction. If persistent sand mildly to remove stain and use solution again if necessary.
Mold & Mildew Mold or mildew needs to be cleaned by hosing with fresh water periodically. Stubborn mold can be pressure hosed and
nylon brushed along the length of the profile. Mild soap solution with warm water can be used for persistent dirt.
Scratches and Abrasions Scratches and mild abrasions will disappear over time, however deep abrasions and
scuffs can be mildly sanded in the direction of the profile to be removed.



© 2018 Versa - All rights reserved
Versa Facebook Page Versa Google Plus Page Versa Pinterest  Page Versa youtube  Page Versa Twitter  Page Versa Instagram  Page